A Bluelab Guardian hydroponic monitor, which tracks temperature, pH, and electrical conductivity, requires a cloud connection to function. Builder Joziti killed that dependency by swapping the factory Wi-Fi board for an Adafruit ESP32-S3 Feather running ESPHome, routing all sensor data to a local Home Assistant instance instead.

The hardware mod is four wires: 5V, GND, TX, and RX tapped from the Guardian's internal header to the ESP32-S3. The ESPHome firmware, published on GitHub at joziti/esphome-guardian, handles the serial protocol translation. No cloud account, no subscription, no external dependency.

Read the full writeup for the serial protocol details and the specific pinout inside the Guardian's enclosure. That is where this gets interesting: Joziti had to reverse-engineer what the factory board was actually saying over UART, and the ESPHome YAML that resulted is reusable for anyone with the same hardware.

[READ ORIGINAL →]